Round Hole Cover Plate for Ceiling & Wall – Snap-In Cap
Round Hole Cover Plate for Ceiling & Wall – Snap-In Cap
Couldn't load pickup availability
-
Ordered
- - -
Order Ready
- - -
Delivered
Round Hole Cover Plate for Ceiling & Wall – Snap-In Cap
GLOBAL DELIVERY
Worldwide Shipping
Fast dispatch with tracking updates
READY TO SHIP
24–48HTurn That Open Hole
Into A Clean Flat Surface
No glue. No drilling. No patch-and-paint job. Press both clips, push the plate into the opening, and let go — the springs do the rest of the work for you.
Fits 2.20–3.35 in
Designed for the openings left behind by old downlights, pipe sleeves, junction boxes and AC line sets — the ones that are too small to patch and too ugly to leave as they are.
A Small Hole.
A Big Difference.
An uncovered opening is not just an eyesore on a finished wall. Air moves through it, dust settles around it, and anything small enough to crawl finds a way in.
- Draughts you can actually feel on cold evenings
- Dust and grit that keeps landing on the same spot
- Insects using the gap as an easy doorway
- A half-finished look in an otherwise tidy room
Spring-Loaded Clips.
Nothing To Support.
Press · Insert · Release
Two stainless steel clips ride on high-tension springs behind the faceplate. Pinch them in, slide the plate into the hole, and release: the clips open out under the surface and press the plate flat against the wall from behind.
- High-tension springs keep the pressure constant, not just on day one
- Stainless steel clips hold up in bathrooms and damp utility rooms
- Everything hides behind the wall — no brackets, no screws on show
- Pull it back out whenever you need access again
Four Moves.
Under A Minute.
Check the opening: it should sit between 56 mm and 85 mm across.
Pinch both spring clips toward the body with your fingers.
Push the plate into the hole until the faceplate meets the surface.
Let go — the clips expand behind the wall and lock it flat.
A stepladder and one pair of hands is the entire tool list. No adhesive to cure, no filler to sand, no paint to match afterwards.
Round For Pipes.
Square For Panels.
Both versions use the same smooth matte ABS faceplate. The edge is shallow, so the cover reads as part of the ceiling instead of a patch stuck on top of it.
Round
Downlight holes, pipe sleeves, flue and extractor openings.
Square
Junction boxes, AC line sets, switch and socket openings.
Ceiling. Wall. Glass.
Pipe Openings.
The same plate works wherever an opening is left behind — indoors, in a garage, or in a utility corner you would rather not look at twice.
- Ceiling holes from removed downlights and spot fittings
- AC wall openings and line-set sleeves
- Glass, panel and partition cut-outs
- Flue, ventilation and extractor openings
- Junction box, socket and switch holes left blank
Measure Once.
It Fits 56–85 mm.
Measure the opening itself — not the old fixture, not the trim ring. If the gap falls inside the 56–85 mm range, the clips have enough travel to grab and hold.
It Comes Off As Easily
As It Goes In.
Removable · reusable
Nothing got walled in. Pinch the clips and the plate lifts away, so you can check wiring, clear a sleeve or take a measurement — then snap it straight back into the same opening.
- No adhesive residue and no filler to scrape off
- No paint touch-up after you take it down
- One plate covers seasonal checks and service calls
Measure. Match. Snap.
Find the opening, measure it across, pick round or square — then let the springs close the gap for good. No glue, no drilling, no repair kit.
